06.15 Penetrologger, with a built-in data logger to store and process up to 1500 measurements data. Using utrasone depth measurement system. Ergonomic design, easy to use, light weight, GPS coordinates, splash-water proof, high accuracy and large measurement range 0-1000N, Graphic and numeric display, flexible programming through PC or penetrologger.

Commissioning of Penetrologger at a Research Center
 

The Penetrologger can be applied in the agricultural as well as in the civil engineering sectors such as:-

General soil science research. Foundation technology. Research into (expected) growing conditions for plants. The detection of compacted (possibly impermeable soil) Research into poor growing conditions for instance trees in the city or in parks. Checking artificially-made compactions.

Graphic display on monitor
 

14.05 field inspection vane tester can be used to determine the maximum shearing force that can be exercised on soil. Measurement in the field (on the surface, in profile pits or at the bottom of bore holes) as well as in the laboratory (on samples) are possible. There are 3 different models for shear stress measurement with a large range up to 200kpa to a depth of 10m. 

Field inspection vane tester
 

Soil Compaction meters are used to determine the density of soil and other material. An operator pushes a rod with attached (ASAE standard) cone into the ground. The resistance of the cone as it is pushed in the ground is measured and recorded in the memory of the compaction meter. The depth of the cone below soil surface is also measured and recorded in memory.

Compaction data is recorded and displayed at one inch intervals, in PSI or kPa. Built-in datalogger eliminates the need to record data manually. Included software allows user to download data, change logger settings and configure the meter.

Measure, log, and review data with the SC-900 Soil Compaction Meter to make better soil management decisions based on data specific to your field. Identify and address specific problem areas on-site and in real time.

Field Scout SC-900 Soil Compaction Meter
 

Soil Compaction meters (often called penetrometers) are used to determine the density of soil and other material. An operator pushes a rod with attached (ASAE standard) cone into the ground. The resistance of the cone is displayed as it is pushed in the ground.

Unseen soil compaction can limit root growth and water and nutrient absorption. This compaction meter enables you to identify compacted areas in pounds per square inch so that you can use deep tillage or other practices recommended for your area based on hard facts.

Features a stainless steel rod with depth marks of 3,6,9,12,15 and 18inches. Analog gauge reacts to pressure applied to cone while penetrating soil.

Economy Soil Compaction Meter
 

Measuring of peat soil moisture value at an oil palm plantation.

TDR soil moisture sensor
 

The TDR 300 has two volumetric water content modes; one for standard soils and one for higher clay soils. In volumetric water content (VWC) mode, the meter converts a measured electrical signal into percent soil moisture content using an equation valid over a wide range of mineral soils. In irrigation mode, the meter displays a relative water content (RWC) on a scale of 0 to 100 corresponding to a user-defined upper and lower soil moisture reference level. Water deficit, the amount of water needed to bring the soil moisture content up to the upper reference level, is also calculated and displayed.

FieldScout TDR 300
 

Use the TDR 200 for accurate, on-the-spot readings of soil moisture to help you make timely water management decisions. Based on the proven time-domain measurement technology, the portable TDR 200 accurately measures soil moisture across the full range of soil moisture conditions. Select from the 1.5in, 3in, 4.8in, or 8 in (3.8cm, 7.5cm,12cm or 20cm) probe rods to suit your measurement depth. The LCD interface provides two modes: volumetric water content and relative water content (irrigation management) mode.

FieldScout TDR 200
 

The TDR 100 is the ideal tool for quick, reliable, and convenient measurement. Whether you're in a field, greenhouse, or laboratory, the TDR 100 will provide the results you want.

Based on the proven time-domain measurement technology, the portable TDR 100 accurately measures soil moisture across the full range of soil moisture conditions. Select from the 1.5in, 3in, 4.8in, or 8 in (3.8cm, 7.5cm, 12cm or 20cm) probe rods to suit your measurement depth. The LCD interface provides two modes: volumetric water content and relative water content (irrigation management) mode.

FieldScout TDR 100